SCM DMC SD 30 RCS 110 43" Automatic Wide Belt Sander 230V Three Phase

GENERAL FEATURES:

• Rubber coated pressing rollers before and after working unit

• 1 HP Inverter variable speed feed unit. Feed speeds set at 10 to 60 feet per minute

• Y-Delta two-stage reduced voltage starter on main motor

• 2 roller Infeed and outfeed table extensions  

• Automatic Electronic Table Positioning Device

• Adjustable sanding drum and pad position for micro precision adjustment

• Electronic digital thickness readout of work table position

• Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability 

• Electronic tracking of abrasive belt 

• Automatic feed mat tracking

• Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt 

• Front and rear emergency stop buttons

• Automatic emergency stop of machine for:

           - sanding belt breaking, tensioning, over tracking

           - opening of the access door to the operating groups 

           - absence of compressed air

           - overload on main motors

• Amperage meter for main motors allows maximum utilization of available horsepower

• Main disconnect switch with the ability to be locked out by padlock

• In feed flexible steel hold down, and anti-kick back plate

• 50 shore, negative profile (waffle style) rubber feed mat

• LOGIC 50 K Electronic Programmer for timing/anti-dubbing of the pad

WORKING UNIT SPECIFICATIONS:
Working Unit Type Roller Motor HP 30 HP Motor Type Single Speed Abrasive Belt Speed 18 mps Drum Size 120 mm Drum Type Steel Calibrating Abrasive Belt Length 75"
 
Working Unit Type Combination Head Motor HP 30 HP Motor Type Single Speed Abrasive Belt Speed 18 mps Drum Size 120 mm Drum Type 45 Sh Rubber Platen Size 50 mm Platens Included Two Abrasive Belt Length 75"
TECHNICAL SPECIFICATIONS
Working Width 1100mm Number of Heads Available 2 Feed Motor 1 HP with Inverter Maximum Work Piece Thickness 170 mm Minimum Work Piece Length 12.5" Abrasive Belt Size 43" X 75" Compressed Air Requirements 6 Bar (88 PSI) Dust Outlets 2 Outlets @ 140 mm Exhaust Requirements 1800 CFM Power Requirements 87 amps @ 230V Three Phase