SCM DMC SD 10 CS 95 37" Automatic Wide Belt Sander with Combi Head

Machine Standard Features:

• Rubber coated pressing rollers before and after sanding unit

• Additional flexible hold-down plate before sanding unit.

• .7 HP 2 speed feed unit. Feed speeds set at 15 and 30 feet per minute

• Electronic digital thickness readout of work table position

• Electronic positioning of the work table 

• Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability 

• Accurate and reliable electronic tracking of abrasive belt 

• Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt 

• Front and rear emergency stop buttons

• Automatic emergency stop of machine for:

• sanding belt breaking, tensioning, over tracking

• opening of the access door to the operating groups 

• absence of compressed air

• overload on main motors

• Amperage meter for main motors allows maximum utilization of available horsepower

• Main disconnect switch with the ability to be locked out by padlock

•  50 shore, negative profile (waffle style) rubber feed mat

• Infeed and Outfeed tables with 2 rollers each

• Automatic table thickness device

Working Unit Specifications
Working Unit Type Combination Head Motor HP 18 HP Motor Type Single Speed Abrasive Belt Speed 18 mps Drum Size 120 mm Drum Type 85 Sh Rubber Platen Size 50 mm Platens Included Two Abrasive Belt Length 60" 1st Working Unit  
Technical Specifications
Working Width 950 mm Number of Heads Available 1 Feed Motor .7 HP Feed Speed 15 or 30 fpm Maximum Work Piece Thickness 160 mm Minimum Work Piece Length 12.5" Abrasive Belt Size 37" X 60" Compressed Air Requirements 6 Bar (88 PSI) Dust Outlets 1 outlet @ 140 mm Exhaust Requirements 900 CFM Power Requirements 54 amps @ 230V Three Phase