Karran Roll-Up Drying Rack for Workstation Sink Ledges
The Karran DR1713SS is a 16-1/2 by 13 inch roll-up drying rack designed to span the integrated ledge of compatible Karran workstation sinks, giving you a dedicated air-drying surface directly over the bowl without occupying counter space.
Key Features
• Workstation ledge fit: Sized to rest on the ledge of compatible Karran workstation sink models rather than sitting on a countertop.
• Roll-up construction: Linked stainless steel rods roll into a compact cylinder for quick, out-of-the-way storage between uses.
• Stainless Steel finish: The rack's stainless material resists the wet environment of an active sink station.
• Over-bowl drainage: Water drips directly into the sink bowl below, keeping the surrounding surface dry.
• Slim profile when rolled: Stored form fits a drawer or cabinet shelf without taking up meaningful space.
Where the DR1713SS Earns Its Place
A workstation sink is built around uninterrupted workflow — prep, rinse, and drain happen in sequence without moving between surfaces. The drying step is where that workflow often stalls, because a conventional drying rack planted on the counter competes with everything else happening nearby. This rack keeps drying in the sink zone. Spread it across the ledge after a rinse cycle, let dishes air dry over the bowl, then roll it away. For a cabinet shop or fabricator running a workstation sink in a finishing room or cleanup station, that kind of friction-free transition matters. For a kitchen renovation where the workstation sink was specified specifically for its workflow benefits, this accessory completes the picture.
Construction and Materials
The rack is built from linked stainless steel rods in a Stainless Steel finish. The linked-rod format is what enables the roll: individual rods flex relative to one another so the flat rack curves into a tight cylinder without any hinge points to fail or catch. When flat, the grid pattern allows air to circulate around dishes from below while water drains straight down into the bowl. The stainless construction holds up to repeated wetting and drying without the rust risk that affects lesser materials in the same environment.
Who This Fits and How to Confirm Compatibility
This rack is made for Karran workstation sinks whose ledge accommodates a 16-1/2 inch wide accessory. Workstation compatibility is ledge-specific: not every Karran sink has an integrated ledge, and ledge dimensions vary across the workstation line. Confirm your sink model is a compatible Karran workstation before ordering. The rack ships as a standalone accessory and is sold separately from any sink or sink kit.
Frequently Asked Questions
Does this rack rest in the bowl or on the ledge?
It rests on the workstation ledge, spanning above the bowl so water drips down into the sink. It is not a bottom grid and does not sit on the bowl floor.
Is a bottom grid for bowl-floor protection included with this rack?
No. This is a standalone drying rack. Bottom grids for Karran sink bowls are separate accessories matched to specific sink models.
Can the rack be used over a non-workstation sink?
The rack is designed for the integrated ledge of compatible Karran workstation sinks. It is not configured to span a standard sink rim, so use outside of a workstation ledge application is not documented.
How is it stored when not in use?
Roll it from one end into a cylinder. The compact rolled form fits in a drawer or on a shelf, so it stays close to the sink without sitting on the counter between uses.
A Cleaner Workflow From Rinse to Done
The right accessories let a workstation sink perform the way it was designed to. This roll-up drying rack keeps the drying step inside the sink zone, clears away in seconds, and stores without claiming permanent counter real estate.
